Payment & Shipping Terms:
|Material:||Epoxy Resin||Color:||Ral Color|
|Type:||Thermosetting||Application Method:||Electrostatic Spray|
This prepared from the epoxy resin,and it has excellent chemical tesistandeand good mechanical properties .It is suiltable for the coating of metsallic appliances that has regor demand on the snti-corrosion,insulating propertees and flexbility.It is suggested to usethis tupe of coating directly in the coating for outdoor appliances.
Standard and low temperature solidification type pouder coatings can be provided.Products of different golss are available,namely,high gloss(above80%),semi gloss950-80%),flat floss(20-50%)and no gloss(below20%).
(The gloss can be abjusted according to the customers to the demand)
1, The product is non-toxic, does not contain solvents and does not contain volatile toxic substances, so there is no toxic, no fire, no "three wastes" emissions and otherpollution problems, in full compliance with the requirements of the state environmental protection law.
2, Raw material utilization rate is high, the powder can be recycled, the utilization rate is over 99%.
3, Before being treated, a one-time construction, no base coating, you can get enough thickness of the coating, easy to achieve automated operation, high production efficiency, therefore it reduces the cost.
4, Coating density, adhesion, impact strength and toughness are good, the edge angle coverage rate is high, it has excellent chemical resistance to chemical corrosion and electrical insulation properties.
5, Powder coating is convenient for storage, transportation safety.
Anyang Star Powder Coating epoxy polyester and wood finish powder coating
|Chemical Class||Synthetic iron oxide alpha-Fe2O3|
|Color Index||Pigment red 101(77491)|
|Use Recommendation||Coating Industry|
|COLOR VALUES AND TINTING STRENGTH|
|Reference||Standard: DIN 6174|
|Binder||Test Paste Based|
|Full Shade||No.001, 2001-01-01|
|Water-Soluble Content [%]||0.5||DIN ISO787 Part 3|
|Sieve Residue(0.045mm)[%]||0.1||DIN 53195|
|Fe2O3 [%]||95.0||DIN 55913 Sheet 2|
|Moisture (After Production) [%]||1.0||DIN ISO787 Part 2|
|Loss on Heating 1000℃1/2h [%]||5.0||DIN 55913 Sheet 2|
Contact Person: Mr zhao